Dry fly fishing is done with line and flies that float, joined by a leader, usually made of fine polyamide monofilament line. The tapered leader is 3 to 5 meters long, thus nearly invisible where the fly is knotted, and the angler can replace the last meter of nylon as required. Unlike sinking fly (nymph) fishing, the "take" on dry flies is visible, explosive and exciting. While trout typically consume about 90% of their diet from below-water sources, the 10% of surface-level consumption by trout is more than enough to keep most anglers busy. Additionally, beginning fly anglers generally prefer dry fly fishing because of the relative ease of detecting a strike and the instant gratification of seeing a trout strike their fly. Nymph fishing may be more productive, but dry fly anglers soon become addicted to the surface strike.
Dry flies may be "attractors", such as the Royal Wulff, or "natural imitators", such as the elk hair caddis, a caddisfly imitation. A beginner may wish to begin with a fly that is easy to see such as a Royal Wulff attractor or a mayfly imitation such as a Parachute Adams. The "parachute" on the Parachute Adams makes the fly land as softly as a natural on the water and has the added benefit of making the fly very visible from the surface. Being able to see the fly is especially helpful to the beginner. The fly should land softly, as if dropped onto the water, with the leader fully extended from the fly line. Due to rivers having faster and slower currents often running side by side, the fly can over take or be overtaken by the line, thus disturbing the fly's drift. Mending is a technique where by one lifts and moves the part of the line that requires re-aligning with the fly's drift, thus extending the drag free drift. The mend can be upstream or downstream depending on the currents carrying the line or fly. To be effective, any mending of the fly line should not disturb the natural drift of the fly. Learning to mend is often much easier if the angler can see the fly.
Once a fish has been caught and landed, the fly may no longer float well. A fly can sometimes be dried and made to float again by "false" casting, casting the fly back and forth in the air. In some cases, the fly can be dried with a small piece of reusable absorbent towel, an amadou patch or chamois and after drying placed and shaken in a container full of fly "dressing"; a hydrophobic solution. A popular solution to a dry fly which refuses to float is simply to replace it with another, similar or identical fly until the original can fully dry, rotating through a set of flies.
Dry fly fishing on small, clear-water streams can be especially productive if the angler stays as low to the ground and as far from the bank as possible, moving upstream with stealth. Trout tend to face upstream and most of their food is carried to them on the current. For this reason, the fish's attention is normally focused into the current; most anglers move and fish "into the current", fishing from a position downstream of the fish's suspected lie. Trout tend to strike their food at current "edges", where faster- and slower-moving waters mix. Obstructions to the stream flow, such as large rocks or nearby pools, provide a "low energy" environment where fish sit and wait for food without expending much energy. Casting upstream to the "edge" of the slower water, the angler can see the fly land and drift slowly back downstream. The challenge in stream fishing is placing the fly with deadly accuracy, within inches of a protective rock for instance, not long range casting. Done properly, the fly seems to be just floating along in the current with a "perfect drift" as if not connected to the fly line. The angler must remain vigilant for the "take" in order to be ready to raise the rod tip and set the hook.
Later in the blog i will show to you some pattens that i talk in the article above!!!
No comments:
Post a Comment